DIY Tips to Clean Electric Fuel Pump Filter

Fuel pump filter is a small, yet one of the critical components of your car. The purpose of having a fuel pump filter in a vehicle is to stop impurities from reaching the car’s engine. If the fuel pump filter is dirty and clogged, the engine will have starting problems and the engine stops intermittently while running. So, it is important to keep it clean.

Now that you know what is fuel pump filter and importance of keeping it clean, you are all set to get started on cleaning it. But wait, do you know the process and order by which the filter has to be cleaned? If the answer is no, then the following section of the article gives you the step-by-step procedure on how to clean electric fuel pump filter by yourself.

DIY tips to clean

Locate fuel pump in the fuel tank

First, you need to figure out where exactly is the fuel pump filter is located in your vehicle. Usually electric filters are either located inside or close to the tank or at the back of the car – it depends on the manufacturer and model of the car.

Disconnect battery first

This is very important, first you need to disconnect the battery before you start the cleaning procedure because as it is an electric pump, any small spark can ignite the fuel.

Block the fuel pipes to avoid fuel gushing

As you have disconnected the battery, you need to stop fuel from gushing out of the disconnected fuel pipes. For blocking the fuel pipes you can either insert an old pencil, thin cocks or rubber bungs or something that is handy and can fit your fuel pipes.

Remove and clean all filters with petrol

Make sure all filters are cleaned by washing them with fresh petrol. Always use fresh petrol when cleaning the filters. Properly clean the filters; make sure there is no dirt or other contaminants.

Clean inside of the filter with clean rag

Now that you have washed the filters with petrol, don’t leave the filters drenched in petrol. Get a clean lint-free rag and wipe off the inside of the pump.

Check sealing gaskets

When cleaning the filters, check for the sealing gaskets and make sure they are in a good condition. If they are not in a good condition, replace them. Damaged gaskets would result in fuel leakage during its functioning.

Fix it back

Once you are done with the cleaning of filters, fix them back to their original position with the screws provided. Make sure you don’t over tighten the screws of the cover.

You can plan the cleaning of the filters according to the manufacturer’s maintenance schedule provided in the owner’s manual.

Auto Detailing – What Does It Involve?

Auto detailing is not the same as washing your car. When you have your car auto detailed, they will clean your car inside and out. When finished, your car will look as if it is brand new. Some of tasks involved in auto detailing include polishing, waxing, and cleaning of the interior and exterior of the car along with removing debris and stains. To become an auto detailer you need to have a keen eye for the tiniest of details.

Exterior auto detailing

When detailing the exterior of your car starts by cleaning your rims and wheels of dirt and dust. Once this is done, the detailers will treat the tire sidewalls and polishing the rims. If there is any wax residue is left around the chrome plates or decals on the vehicle it is carefully wiped away. They may even treat the windows with a rain repellent. They will also clean the engine using degreasers or by steam. The underside of the rails and hood are polished after being cleaned. They will wash, clean, and wax the exterior of your car, including cleaning the lights.

Interior auto detailing

When detailing the inside of your car they will thoroughly vacuum your car, including the upholstery, and mats. This part of the job can include using a number of different products. It depends on the condition of the inside of your car. They can use rug shampoo, spot cleaners, and upholstery foam cleaner. If the car has cloth seats they may use a wet/dry vacuum on them to help remove most stains. It also makes your seats and carpet look new, with the exception of existing physical damage. The vinyl areas inside your car like the console, dashboard, and door panel trim are cleaned. Then they are treated with conditioner in order to keep the vinyl pliable. The gas and brake pedals are also cleaned. They are not conditioned to prevent your foot from slipping off the pedal. The covering over the speedometer, gas gauge, and other gauges are also cleaned. To ensure that the slats of the heater and air conditioning vents are clean they often use Q-tips. Q -tips also are used to clean the seams in the console that collect dirt and dust. All of the interior glass is thoroughly cleaned and washed, making sure that there is no film or streaking that can reflect impair the driver’s vision from nighttime headlights or low angles of sunlight.

Cost of auto detailing

Auto detailing can range from $100 to as much as $275. It depends on the size of the vehicle, the package you choose, and if you want to add any extras such as a special conditioner. Some shops may base their price on how dirty your vehicle is.

Car Detailing Tips: How to Keep Your Tyres Looking Good

Keeping your tyres looking good as new is all in the way you drive and how you clean that part of your car. People will notice dirty wheels and it can give the car a bad look. Car detailing starts with keeping your tyres clean and amazing.

Treading on the tyres can easily be worn away when you are driving. You can minimise the amount of damage you do by driving correctly. Sudden braking and spinning can wear away the tread detail very quickly. Only apply sudden braking if safety calls for it. Always start applying the brakes when you are about five to ten meters away from the car in front of you. Spinning can be prevented by releasing the clutch as you apply fuel to the engine.

Did you know that there is a practical way to get your tyres to be glossy? This is known as dressing or protectant. Many car dealers will apply this substance on the tyres to give the car a glossier and more attractive appearance. It also protects the rubber from the UV lights of the sun and the toxic air pollution that degrades the quality rubber surface. The dressing or protectant also adds a layer to prevent any oil or dirt from sticking onto your tyre. This chemical isn’t greasy so it won’t cause you to spin on the road. Rather it is more of a non-stick surface that can grip onto the gravel or tar road.

Sunlight has the harsh ability to age and damage the rubber on the tyres. Over time you will start experiencing the tyres to be brittle and it can break with the slightest hit. However, you can avoid this from happening.

When cleaning your tyres you need to use a cloth, a high pressure hose and the cleaning detergent of your choice. You always start with hosing down the tyres to remove any dirt, oil or residue. This shouldn’t take long and will make the cleaning process easier. After you have hosed the dirt away you can apply the wheel detergent. To remove oil from the wheels you will require than just water so a wheel detergent would be ideal. Next, you can use brushes that can clean the treads and crevices. The cloth will absorb any water that was on the rim and leave it looking clean and sparkly.

Status is a big part of society so doing a bit of cleaning and shining can give you that little boost. Tyres are important when you are a driver. They allow you to move forward and to climb an incline without over-using your throttle. So keep them clean and in good condition.

Top Tips On How To Get The Best Shine From Your Car

We all love that brilliant shine of a new car in the dealer’s showroom or at an auto show. There are hundreds of car care products and treatments available. The question is what works best and how do you do it?

First, you must properly clean and wash your car. Polishing and waxing a unclean car is sure to leave hairline scratches from dirt and debris on the car. Proper car washing and cleaning should be a main staple of any car care regimen or treatment. It is a proven fact that cars that receive routine car washes will last longer (as evidenced in a recent Popular Mechanics magazine). To properly wash your car, first rinse it off. Get the whole car wet and try to spray off any loose dirt and debris. Then use specific car wash soap (regular household items and chemicals are usually too harsh and can strip the wax or sealant right off) and a soft sponge or towel. Wash one panel or area at a time and rinse when done so the suds and soap won’t dry on the paint. When done dry off the car with clean terry towels or microfiber towels (a chamois works great also).

Next, examine your car. Look at the bumpers, behind the tires, the roof, etc… Are there any contaminants like bug splatter, bird droppings, tree sap, etc… that are still there after washing? You can try and rewash these areas with a little more pressure to try and loosen them up. If they still don’t come off, you will need a contaminant remover. This is a spray and each has their own unique formula and set of directions. Some are similar to foaming glass cleaners and others are a thick emulsion that will sit right on the problem area and not drip off. These contaminant sprays will remove most stuck on road debris and there are formulas specifically for road tar and tree sap as they can be more difficult. Follow the directions and then rinse and dry.

To smooth out any imperfections in the paint we recommend a cleaner wax. According to a study by Consumer Reports of every wax currently produced it was found that Turtle Wax was the best for value, durability and shine. So, there is no need to waste your money on expensive treatments that will not deliver a finish as well as a $2 bottle of Turtle Wax. Apply the cleaner wax in small circular motions and do one panel at a time, same as you did with car washing. Let the cleaner wax dry to a white haze and then buff with a clean terry cloth. Repeat as necessary.

Next, what we recommend is that you use a polymer car polish (again, there is no need for expensive treatments – you are just wasting your money). A good polymer car polish can be obtained at Walmart for between $2 and $5. They always come as a liquid and are very easy to apply and really do last longer than any car wax (up to 1 year and 50 car washes as some labels state). Apply to the whole car and buff dry. Apply 2-3 coats for maximum protection.

After the car polish we recommend a high class carnauba wax (again there is no need for expensive treatments). Turtle wax platinum car wax is around $5-$7 and so are some Meguiars and Mothers top waxes. This will give you a better than new deep and wet looking shine. Apply 2 coats in similar fashion to the cleaner wax. Wait until you see the resultant shine from wax on top of polish. It is unbelievable and gives your car the best shine possible and also the maximum protection available. This is how they get that extra deep shine on cars at the auto shows – it works and you will be amazed.

Best Car Detailing Tips And Techniques

Maintaining the condition of your vehicle can prevent significant depreciation by keeping it clean and protecting the bodywork against deterioration. Removing the sand and grit that settle on the surface can prevent the paint from eroding or sustaining scratches. There are a number of techniques to apply and products to use to ensure that the paint and features are best maintained.

Scratches, rust, and chipped paint can result from the accumulation of dirt and poor cleaning methods. Using improper products including dishwasher liquid can remove the shine from the body and degrade the overall appeal of the car that can take time and money to restore. To prevent degrading the vehicle and ensure that it remains well maintained, there are a number of washing techniques that can be applied to keep cars looking as good as new.

Invest in good wash and wax products that are developed for use with vehicles and provide extra protection against regular scuffs and sand. These ranges have been developed with quality compounds to create a barrier of protection for cars. These items are important when regular washes are performed and should never be replaced with soaps or household detergents that could compromise the appeal and the integrity of bodywork.

Do not wash a vehicle by applying the product to the body without rinsing the exterior first. Washing a car with the grit and sand remaining on the metal work will cause minor scratches and general deterioration that affects the overall shine and appeal of the paintwork. Simply removing the dirt with a simple rinse can prevent against these scuffs and ensure that the exterior is well maintained.

When keeping vehicles in mint condition, it requires the maintenance of the interior and the exterior. One of the most common causes for poor air conditioner service or the presence of foul odors inside the automobile includes the accumulation of dirt and dust in the vents of the system. Keeping the interior smelling new and fresh includes clearing the vents of grime and grit blowing air into the vents and wiping with a soft clean cloth.

All metallic features must be carefully cleaned and maintained with the use of compatible auto products. Keeping the mirrors and rims in good condition includes the use of the right products that will remove scuffs and improve its shine. Taking the necessary steps can assist in producing exceptional results to keep the motor vehicle in the best possible condition.

Use the correct tools to wash the car to prevent scratching the surface or failure to produce a natural shine. The application of a soft sponge with circular motions along the body can remove dirt while producing a high shine. Do not make use of regular products or brushes that could cause additional damages.

Car washing is best performed by a professional service offering superior vacuuming, polishing and maintenance. General management performed at home requires the use of the proper tools and products. These steps will ensure that the appearance and condition of vehicles are well kept and protected against expensive damages.